Why your Vape tastes burned and how to fix it
What causes burns?
When there is no liquid in the core rod or liquid core is insufficient, the power supply to the atomizer may cause burns. No evaporation of liquid, the coil begins to burn the fuse, and the user inhales basically cotton burning. Here are some of the most common causes of burns and some suggestions to help avoid these problems arise.
Evaporation power that exceeds the limit of the coil evaporates the e-liquid too fast. When this happens, the coil can burn the wick, even if no juice there. Always stay within the recommended power margins.smok vape
A continuously inhaling the wick dries quickly. If you notice a slight smell of toast and the feeling that comes a smell of candy, please temporarily put the vaporizer. This will allow the liquid to cover the tip of the wick dried.
Using e-liquid high VG
Not all spray atomization is the same. Some storage tanks vaporizer may contain high VG juice while other storage tanks usually require a 50% PG PG or higher to run correctly. A rule of good practice is to check the size of the wick channel. If the diameter of these holes is small, its water tank can not be well suited to the high juice VG.RPM80 Pro
Bobbin is properly oiled
This is probably the most common problem in the list. Irrigation head coil is essentially the process of soaking the wicks with e-liquid, so they are ready for first use. If you want to avoid burns, always remember to infuse the coil correctly.
Install the coil: stop burning
Though the idea is the same, the priming process of the coil varies depending on the equipment used. These are some of the most commonly used methods of vape infusion.
How vaporizer coil first tank
All vape tanks with replaceable heads coil have roughly the same structure and the same simple steps required for priming. This process needs to be repeated every time the coil is replaced.
New coil output box
E-drop some liquid in the wick hole and coil head (3-4 drops are sufficient)
Mount the water tank and pour the juice
Screw your tank in the Department of Defense and let stand for 10 minutes
Inhalation at the top of the fuel tank without ignition accelerate the process of
Vape for mods with power adjustment function, you have to start with the lowest recommended power and gradually increase to find the best position
Note that as more liquid can accumulate inside the coil, you may experience some regurgitation during the first aspiration. Do not go away, and you are using a variable power module, try increasing the power a few times, but be sure not to exceed the power limit of the coil, as it is likely to burn.